Which itself is for marketing reasons, a manufacturer would find it difficult to compete with others using units that make their drives look larger or cheaper at “same capacity”.
There is also the smaller amount w!ndows will secretly waste for its own pleasure (few GiB iirc). And an even smaller amount that gets wasted in partitioning. Usually around 5MiB, you can reduce it to 16kiB with some manual configuration in gdisk, or you can skip partition tables entirely for some end-game cursedness. And then the filesystem will take some. ext4 takes based on the number of inodes, for large drives that can be tens of GiB. Btrfs takes almost nothing (though in the background allocates in steps of 1GiB, so some tools might show 2GiB used as soon as data is written). Then if you try to sum all files on disk, that will land even lower for many more reasons.
Because back in the 1980s RAM chips were individually sold and the number of address pins exactly matched the 2^(# of pins) amount of memory addresses contained in the chip (for cost savings purposes) and only with the later column strobe addressing DRAM did that change but at that point they couldn’t deviate from the 1024 standard without getting sued (a couple did and went out of business).
And since the RAM chips themselves are stuck using 1024 and the RAM sticks are made of matching RAM chips (for cost and performance reasons); it will remain that way until people start buying systems on a chip with embedded RAM.
It’s a sufficient explanation. I don’t know why the meme has the highest IQ person say “I don’t know”, unless the joke is that it’s easier than explaining…
I don’t know why the meme has the highest IQ person say
Every time I see the midwit meme format, it reads like OP imagines that they’re the 145 IQ guy who is above it all, when all other evidence suggests that they’re closer to the 55 IQ guy.
But the smallprint explanation in the middle of the meme is actually spot on. Whoever made this does know the correct explanation and seemingly also knows that it comes out to 931 GB from the unit conversion alone.
And it gets more complicated when we get to the metadata and filesystem structure. So, you technically never get to store 931GB, I wonder what the (average) ratio of metadata to data is? 3:1?
I want to agree with you two, because I hate competing standards, but you gotta admit gigabyte was a poor choice from the start because it took the SI prefix and made it mean something else. Creating Gibi is just correcting that mistake
The OS uses 1024 and the drive manufacturers are using 1000.
Which is why a 1TB drive shows 931GiB of capacity. (1024 GiB =1 TiB, 1024MiB =1 GiB, 1024KiB =1MiB, 1024 Bytes =1KiB) but the drive manufacturers using SI prefixes doing 1000 Bytes =1 KB, 1000 KB = 1MB, 1000MB = 1GB, 1000GB = 1TB.
Thus the discrepancy.
Which itself is for marketing reasons, a manufacturer would find it difficult to compete with others using units that make their drives look larger or cheaper at “same capacity”.
There is also the smaller amount w!ndows will secretly waste for its own pleasure (few GiB iirc). And an even smaller amount that gets wasted in partitioning. Usually around 5MiB, you can reduce it to 16kiB with some manual configuration in gdisk, or you can skip partition tables entirely for some end-game cursedness. And then the filesystem will take some. ext4 takes based on the number of inodes, for large drives that can be tens of GiB. Btrfs takes almost nothing (though in the background allocates in steps of 1GiB, so some tools might show 2GiB used as soon as data is written). Then if you try to sum all files on disk, that will land even lower for many more reasons.
At the beginning of time, K/M/G etc was based on 1024. This was considered a bad move by some people.
What I don’t get is memory packages don’t come in thousands, but in volumes dividable by 1024, so why the 1TB=1000 somethings…
Because back in the 1980s RAM chips were individually sold and the number of address pins exactly matched the 2^(# of pins) amount of memory addresses contained in the chip (for cost savings purposes) and only with the later column strobe addressing DRAM did that change but at that point they couldn’t deviate from the 1024 standard without getting sued (a couple did and went out of business).
And since the RAM chips themselves are stuck using 1024 and the RAM sticks are made of matching RAM chips (for cost and performance reasons); it will remain that way until people start buying systems on a chip with embedded RAM.
Yeah:
1000 GB × 1000 × 1000 × 1000 / 1024 / 1024 / 1024 = 931.32 GiB
It’s a sufficient explanation. I don’t know why the meme has the highest IQ person say “I don’t know”, unless the joke is that it’s easier than explaining…
Every time I see the midwit meme format, it reads like OP imagines that they’re the 145 IQ guy who is above it all, when all other evidence suggests that they’re closer to the 55 IQ guy.
that is what happens when 100 iq meme author tries to think like 145 iq person, which is of course impossible by definition…
But the smallprint explanation in the middle of the meme is actually spot on. Whoever made this does know the correct explanation and seemingly also knows that it comes out to 931 GB from the unit conversion alone.
I’m really not sure this meme makes sense. 😅
I’m guessing that IDK is for why they write it as GB and not GiB
And it gets more complicated when we get to the metadata and filesystem structure. So, you technically never get to store 931GB, I wonder what the (average) ratio of metadata to data is? 3:1?
Depends on the file system. If you are using FAT-8; it is 256:1 if you are on ZFS it is as low as 1:4.
It also depends on composition of the data stored. If it is Linux ISOs; it is 4GB:64KB. If it is old C source code; it is 512B:4KB on ext4
The problem arises when the OS uses GiB but labels them GB, like Windows does.
No, the problem is making up a new word (gibibyte) and expecting people to use it when there’s already a word for that (gigabyte).
It’s the hard drive manufacturers that should change.
Let’s see someone willing to give you 1024g of gold for the price of 1Kg gold.
I want to agree with you, but the war is lost. Giga is billion and Gibi is 2^30
I want to agree with you two, because I hate competing standards, but you gotta admit gigabyte was a poor choice from the start because it took the SI prefix and made it mean something else. Creating Gibi is just correcting that mistake
Agreed, metric prefixes should always remain consistent. Computers can read both though, so why doesn’t windows?
I propose a new standard.
Ghibli[byte/bit]s.
… no I will not expand or further clarify.
Look at Mr. “100 IQ” over here
128 IQ*